Bjm-pumps KB110H-F Manual do Utilizador

Version 4/21/2014 INSTALLATION, OPERATION & MAINTENANCE MANUAL FARHENHEIT™ KB-F SERIES TOP DISCHARGE HEAVY DUTY DEWATERING WITH AGITATOR E

9 PUMP OPERATION This pump is designed to handle dirty water that contains some solids. It is not designed to pump volatile, or flammable liqu

10 TYPICAL AUTOMATIC DEWATERING INSTALLATION NOTE: Maximum recommended starts should not exceed 10 times per hour. Three phase pumps need a s

11 THREE PHASE WIRING INSTRUCTION FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER SOURCE BEFORE HANDLING. “Risk of electrical s

12 Before installing a pump, check the pump rotation to insure that wiring has been connected properly to power source, and that the gre

13 SERVICING YOUR SUBMERSIBLE PUMP Pump should be disconnected from the electric power supply before proceeding to do any service or maintenance. To

14 9) Remove the screws that hold the oil chamber cover in place & remove the oil. 10) Replace the mechanical seal if necessary. 11) Replace the

15 EXPLODED VIEW OF KB55-F, 55H-F, 75-F, 75H-F, 110-F, 110H-F

16

17 KB-F SERIES PARTS LIST Pump Model KB55-F KB55H-F KB75-F KB75H-F KB110-F KB110H-FPos. No. Part Description Item # Item # Item # Item # Item # Item

18 THREE PHASE WIRING DIAGRAMS 230V MODELS KB55-F, 55H-F, 75-F, 75H-F, 110-F, 110H-F

19 460V MODELS KB55-F, 55H-F, 75-F, 75H-F, 110-F, 110H-F

20 575V MODELS KB55-F, 55H-F, 75-F, 75R-F, 110-F, 110H-F

21 SEAL MINDER® - THERMAL MOTOR SENSOR SWITCH (For high temperature pump models) Seal Minder: Also known as a seal failure circuit (or moisture det

22

23 BJM Pumps, LLC 123 Spencer Plain Road Old Saybrook, CT 06475, U.S.A. WARRANTY AND LIMITATION OF LIABILITY Unless otherwise expressly authoriz

START-UP REPORT FORM START-UP REPORT FORM This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a

START-UP REPORT FORM presence? Are guide rails exactly vertical? Yes No Is base elbow installed level? Yes No Liquid level controls: Model Is

START-UP REPORT FORM Voltage supply at panel line connection, pump on L1-L2 L2-L3 L3-L1 Amperage load connection, pump on L1 L2 L3 FINAL CHECK Is p

NOTES:

FARHENHEIT™ is a trademark of BJM Pumps, LLC. BJM Pumps & Seal Minder is a registered trademark of BJM Pumps, LLC Copyright © 2009-2013 BJM Pum

TABLE OF CONTENTS INTRODUCTION ...

4 INTRODUCTION This Installation, Operation and Maintenance manual provides important information on safety and the proper inspection, disassem

4 Hazards or unsafe practices which COULD result in personal injury or product or property damage. These instructions describe the procedure requir

5 Pumps and related equipment must be installed and operated according to all national, local and industry standards. INSPECTION Review al

6 OIL FILL QUANTITY/TYPE Qty. oil in seal chamber Models U.S. fl. oz. C.C. Type of oil KB55-F, 55H-F, 75-F, 75H-F, 110-F, 110H-F 49 1450 ISO 32 NS

7  Do not run pump dry.  Pump liquid should not exceed a maximum temperature of 200°F (93°C).  Never place the pump on loose or soft ground.

8